Manual

Table Of Contents
116
Appendix H: Replacing the Hard Drive
Replacing the Hard Drive
To replace the hard disk:
1. Carefully position the new hard drive on the mounting
plate—the raised cont
our of the mounting plate should
be facing up (see figure 34.1)—and secure with the
four screws.
2. Place the mounting plate (with attached hard disk) on
the four mounting posts of the circ
uit board. Observe
that the mounting plate has an inset to allow for correct
placement on the circuit board (see figure 34.2).
3. Secure the mounting plate (with attached hard disk) to
the four mounting post with the fo
ur screws.
4. Reconnect the cables to the hard disk. Make sure the
cables are connecte
d firmly.
5. Carefully replace the housing and reattach the four
screws—h
ousing and screws holes should line
up.
6. Reconnect all cameras and cables. Re-mount the unit
the back of your monitor if desired.
7. Power on the system. If you
have installed a new hard
disk, you must format the hard disk befo
re using the
system.
Figure 34.1 Observe the raised contour
Figure 34.3 Firmly reconnect the drive cables
Figure 34.2 Replace the HDD and mounting plate