Manual

28
Using the Main Menu
SPOT
Adjust the settings for the Spot monitor (not
included).
To change Spot settings:
1. Press the buttons to select a
menu option. Press the buttons to
change the value of the selected option.
• SPOT MODE: Press the buttons to
select the following:
• MANUAL: Manually select the channel for
the Spot Monitor
• SEQU
ENCE: Single channels (full screen)
w
ill be displayed in an alternating
sequence
• EVEN
T: The channel wher
e an event
(motion, alarm, sensor) has occurred will
be displayed on the Spot Monitor
• SPOT SEQUENCE TIME: Set the dwell
time for the channels appearing on the
spot monitor (from 1~60 seconds). The
higher the dwell time, the longer the
channel will be displayed on screen on the
spot monitor.
• VIDEO LOSS SKIP: You can omit
channels with video loss from the
sequence to the spot monitor. Set to ON/
OFF.
2. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY
or SAVE AND EXIT
to save your settings.
CAMERA
Adjust brightness, contrast, hue, and
saturation for each camera.
To change camera settings:
1. Press the buttons to select a
menu option. Press the buttons to
change the value of the following options
• BRIGHTNESS
• CON
TRAST
• HUE
• SATURATION
You can chang
e the value from 0%~100%.
2. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SA
VE AN
D EXIT
to save your settings.
Figure 9.6 Spot menu
Figure 9.7 Camera menu