Manual

35
Using the Main Menu
MOTION DETECTION
Configure motion detection for all camera
channels.
To set motion detection:
1. Under CHANNEL, press the buttons
to select the channel for which to set
motion de
tection.
2. Under SENSITIVITY, press th
e
buttons to set the motion sensitivity from
1~5. The
higher the sensitivity, the
more
sensitive the detection.
3. Under AREA SETUP, press the button
to open the Area Setup Grid.
4. Press the buttons to
select cells on the grid. Press the
button to enable/disable the cell. When
finished
, press the button to ex
it the
Area Setup Grid.
NOTE: An enab
led (active) cell is clear; a
disab
led (inactive) cell is green.
5. Under TEST MOTION, press the
button to test your motion detection
settings
. To verify y
our settings, wave your
hand in front of the selected camera:
active cells will appear pink while inactive
cells will appear green.
6. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SAVE AN
D EXIT
to save your settings.
Figure 11.0 Motion Detection grid
Figure 11.1 Motion grid setup
EVENT
Open the Event menu to configure the following options:
• MOTION DETECTION
• EVENT SCREEN MODE
• EVENT CHECK
• EVENT MESSAGE
• EVENT MESSAGE RESET
• EVENT BUZZER
• SENSOR INPUT
• RELAY OUTPUT