Manual

Table Of Contents
37
Using the Main Menu
SENSOR INPUT
Configure the sensors connected to the
system. Depending on your model, you can
connect from 4 to 16 sensors.
To set sensor input:
1. Press the buttons to select the
sensor channel. Press the buttons
to switch between pages.
2. Press the buttons to set the value of
the sensor input:
NORMAL OPEN: The sensor is o
pen at
normal times
NORMAL CLOSE: The senor is closed at
normal times
NOT USED: No sensors are connected to
the system (default for all channels)
3. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY
or SAVE AND EXIT
to save your settings.
RELAY OUTPUT
Configure the relays on the system.
To set the relay output:
1. Select RELAY SELECT and press the
buttons to set the type of relay:
2. Select RELAY OUTPUT TIME and
press
the buttons to set the length
of the
relay time: 1~30 seconds.
3. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SA
VE AN
D EXIT
to save your settings.
NOTE: You can set the Relay Output for
channels 1
~4 by setting the relay to the
following:
POWER: The relay is working when the
system is powered off
USER: The user can operate th
e relay
manually: press the FUNCTION butto
n
to operate Relay 4 manually.
NC— NO: and then press the button
NO—
NC: and then press the button
Figure 11.3 Sensor input menu
Figure 11.4 Relay Output menu
• REC
• USER
• POWER (N.C.)
• HDD ERROR
• MOTION
• LOSS
• ALARM
• NOT USED