Manual

38
Using the Main Menu
HDD
Format a new hard disk and configure internal
hard disk settings.
To initialize the hard disk:
1. From the System menu, select HDD and
press the button.
2. From the HDD menu,
press the button
to open the HDD Initialize screen.
3. Select YES a
nd press the button.
[Select
NO and press the button to
cancel, or the button.] The
system
formats the hard disk, erasing all recorded
video data. System settings and
configurations rema
in intact. After a few
moments the system returns to the HDD
menu.
4. Press the button on the remote
control until you see the Save/Exit screen.
Select SAVE ONLY or SA
VE AN
D EXIT
to save your settings.
NOTE: If you replace the internal 2
.5" hard
disk, you should always initialize the new
disk. If you do not initialize (format) the new
hard disk, it may not be properly read by the
system.
Figure 12.0 HDD menu
ATTENTION: Initializing (formatting)
the HDD erases all data on the hard
disk. This step cannot be undone.
SYSTEM
Open the System menu to configure the following options:
• HDD
• CLOCK
• VIDEO STANDARD
• LANGUAGE
• REMOTE CONTROL ID
• KEY ECHO
• ADVANCED SETUP
• FIRMWARE UPDATE