User's Manual

Touch Screen Icons
7
Tap to begin comparing stored images with the live camera feed on a
split-screen. When you tap the icon, the image gallery opens. Select an
image from the gallery to compare with the live image. The screen will
split, showing the stored image and the live image side by side.
Additional touch-screen icons are active in this mode, see figure below.
1. Live image (default position: left)
2. Stored image (default position: right)
3. Tap the icon and drag the stored image as desired, tap icon when
done
4. Swap left and right images
5. Return to Gallery to select a different image
6. Selected area of image (see step 3 above)
Tap to rotate image clockwise (90°, 180°, and 270°).
Tap to switch the dust elimination filter on or off (for use with dual cam-
era models and mirror accessories).
For dual camera models and for single camera models using mirror ac-
cessories, tap this icon to show a split screen with the forward facing
(F) and side facing (S) views shown on a split screen.
Same as icon directly above but, when tapped, the worklight toggles di-
rection from side to forward or from forward to side.
Tap to show the camera image in a ‘negative’ contrast format. Tap again
to return to normal operation.
Tap to open the white balance menu described below:
• Default: Reset to the factory default.
• Calibration: Point to a white surface, tap the box in the centre of the
screen or press the check mark √ button, and then confirm.
• Custom: Set the White Balance manually using the RGB sliders.
#NAS100101; r. AB/85156/85156; en-US
15