Installation Manual

9
FLO Home X5 | Installation guide | o.com | January 2019
9 Install the front housing of the charging station:
A) Hang the top by presenting the front housing at an angle of about 30 degrees, then
pivot vertically without forcing.
B) Tighten the 2 front screws with a nominal torque of 55 lbs-in.
Detail A
About
30°
A
B
10 Switch on the electrical circuit breaker.
Wiring the NEMA 6-50
Power Cord Plug
1 Remove the rubber cap (located at the bottom
of the charging station).
2 Pull cables inside the station. Ensure the plug blades
are facing the wall.
3 Follow steps, ‘‘Installing the Station’’ 7 to 9 (p8 and p9).
4 Connect to power outlet
5 Switch on the electrical circuit breaker.