Instructions / Assembly

GLASS CORNER SHELF INSTALLATION

TO INSTALL THE SHELVES YOU WILL NEED A PAINTABLE ADHESIVE CAULKING,

OR ANY COLOR AVAILABLE THAT IS SIMILAR TO YOUR WALL PAINT

(WE DO SUGGEST

AND/OR OFFER “ALL-PURPOSE CAULKING” IN WHITE, BEIGE, LIGHT GRAY AND BROWN). FOR

COSMETIC REASONS DO NOT USE CLEAR OR SILICONE CAULIKNG.

STEP 1- MARK THE SPOT WHERE YOU WOULD LIKE THE CORNER

SHELF TO GO. IF YOU ARE INSTALLING

A RECTANGLE SHELF, BE SURE TO LABEL ONE

WALL FOR THE LONG SIDE OF THE SHELF AND THE OTHER

WALL FOR THE SHORT SIDE OF THE SHELF

STEP 2 – USE A LEVEL AND DRAW TWO LEVELED

LINES AT ABOUT THE SAME LENGTH OF

THE SHELF, ONE AT EACH SIDE OF THE

WALL WHERE THE SHELF IS GOING TO BE INSTALLED.

STEP 3 – USING THE SUPPLIED TEMPLATE MARK THE

POSITION OF THE GROOVES ON THE WALL. THE ARROW

ON THE TEMPLATE MUST POINT TO THE CORNER.

STEP 4 – USE DRILL TO START CUTTING THE GROOVES,

FOLLOWED BY USING THE WALL-SAW. ONLY CUT THE AREA THAT

IS MARKED. THEN, TEST TO FIT THE SHELF INTO THE

GROOVES. CLEAN ALL GROOVES AND WALLS FREE OF DUST.

ALSO:

YOU CAN CUT THE GROOVES

WITH A MULTI-TOOL. MULTI-

TOOL IS AN EXCELLENT TOOL

FOR DRYWALL, PLASTER WALLS

OR WOOD APPLICATIONS

STEP 5 – APPLY 3/8” BEAD OF CAULKING ADHESIVE JUST BELOW THE

LINES, AND IN THE GROOVES. INSTALL THE SHELF IMMEDIATELY

BEFORE THE CAULKING DRIES .AFTER INSTALLATION, FILL ALL GAPS

WITH MORE CAULKING IF NEEDED.

STEP 6 – PUSH THE SHELF IN PLACE. THEN USING A WET SPONGE

CLEAN ALL EXCESS CAULKING. LET IT DRY

OVER NIGHT. IF NECESSARY, YOU MAY PATCH AND

PAINT ANY GAPS FOR A BETTER APPEARANCE.

PAGE 1
GLASS CORNER SHELF INSTALLATION TO INSTALL THE SHELVES YOU WILL NEED A PAINTABLE ADHESIVE CAULKING, OR ANY COLOR AVAILABLE THAT IS SIMILAR TO YOUR WALL PAINT (WE DO SUGGEST AND/OR OFFER “ALL-PURPOSE CAULKING” IN WHITE, BEIGE, LIGHT GRAY AND BROWN). FOR COSMETIC REASONS DO NOT USE CLEAR OR SILICONE CAULIKNG. STEP 1- MARK THE SPOT WHERE YOU WOULD LIKE THE CORNER SHELF TO GO.
PAGE 2
Shelf Installation (“Before” Tiles Installation) The Tile installer can prep the wall for shelf installation by cutting the grooves and leaving them open. It is best to mark and cut the grooves above the grout line. Use the template to mark the grooves. You may have to cut the tile backer board to let the shelf in. Shelf can easily be installed after the grout is done and dry. Follow instructions in step 5 & 6 to finish the installation.