Specification

CWF-UV NATURAL 275 VOC FLD542
Product name
3
Product code
Date of issue
Version
00409163
18 August 2015
Section 15. Regulatory information
SARA 313
SARA 313 notifications must not be detached from the SDS and any copying and redistribution of the SDS shall include
copying and redistribution of the notice attached to copies of the SDS subsequently redistributed.
Additional environmental information is contained on the Environmental Data Sheet for this product, which
can be obtained from your PPG representative.
Supplier notification
Chemical name
:
ethanediol
107-21-1
1 - 5
CAS number
Concentration
Section 16. Other information
Key to abbreviations
:
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL 73/78 = International Convention for the Prevention of Pollution From Ships,
1973 as modified by the Protocol of 1978. ("Marpol" = marine pollution)
UN = United Nations
Hazardous Material Information System (U.S.A.)
0
0
0
National Fire Protection Association (U.S.A.)
Health
Instability
Flammability
Health
Flammability
Physical hazards
Disclaimer
The information contained in this data sheet is based on present scientific and technical knowledge. The purpose of this
information is to draw attention to the health and safety aspects concerning the products supplied by PPG, and to
recommend precautionary measures for the storage and handling of the products. No warranty or guarantee is given in
respect of the properties of the products. No liability can be accepted for any failure to observe the precautionary measures
described in this data sheet or for any misuse of the products.
Date of previous issue
12/18/2014
:
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4 representing significant hazards or
risks Although HMIS® ratings are not required on MSDSs under 29 CFR 1910.1200, the preparer may choose to provide them. HMIS® ratings are
to be used with a fully implemented HMIS® program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS®
materials may be purchased exclusively from J. J. Keller [phone].
The customer is responsible for determining the PPE code for this material.
Indicates information that has changed from previously issued version.
Organization that prepared
the MSDS
:
EHS
:
:
:
:
:
:
3
*
3
0
( * ) - Chronic effects
United States
Page: 12/12