Use and Care Manual

The surface of all Florence Manufacturing clear aluminum
or powder coated products may be cleaned of dirt or
grime with a soft cloth dampened with any mild detergent
or properly diluted biodegradable, water-based cleaner,
such as “Simple Green™”
1
. Wipe from top to bottom to
avoid run-down. Avoid use of abrasives, which might
damage the product surface. Rinse with plain water and
dry
2
. Avoid cleaning during extreme temperature conditions.
To varying extents, depending upon the color, it may be
possible to remove some spray-paint or marker-applied
graffiti from powder coated surfaces by using a stronger
cleaner such as “Krud Kutter™”
3
or a mild petroleum-based
solvent, such as mineral spirits. Test-clean a small area first,
a few seconds at a time. Do not allow chemical to remain
on surface for an indefinite period, as this may damage
the surface of the product. Remove any residue left with a
mild cleaner, followed by water rinse as noted above.
Matching touch-up paint products may be available from
an Authorized Florence Dealer for products which utilize
powder coat finishes.
If a mailbox lock in outdoor equipment becomes clogged
with ice due to extreme winter weather conditions, the lock manufacturer suggests using “Tri-Flow®
Superior Lubricant Aerosol”
4
. Spray the Tri-Flow® Lubricant
5
directly into the keyhole and onto the key.
Slide the key in and out of the lock several times to spread the lubricant. Do not apply too much product,
as a small amount is sufficient. Wipe off any excess lubricant from the lock and key.
1 Simple Green™, product #13102, is manufactured by Sunshine Makers Inc of California, 800-228-0709, [e-mail].
2 In foggy coastal regions, frequent cycles of condensation and drying can create a heavy build-up of atmospheric salts and dirt that may
adhere tenaciously. This requires that cleaning be done more frequently than in other metropolitan areas where rainfall is more frequent
(AAMA Standard 609 & 610-02).
3 Krud Kutter™, product #GR32, is manufactured by Supreme Chemicals of Georgia, 800-466-7126, [e-mail].
4 Tri-Flow® Superior Lubricant Aerosol, product #TF20009, is manufactured by The Sherwin-Williams Company of Ohio, 800-474-3794.
5 This product is a light-viscosity lube that allows for deep penetration into hard-to-reach moving parts, providing optimum lubrication under
extreme temperatures (-60 to 475°F) and humidity. Product includes formulated solvents that soften and remove dirt and contaminants, and
special additives that displace moisture and prevent rust and corrosion.
florencemailboxes.com/cleaning
Care and Cleaning
Important Product Info
Leading the Centralized Mailbox Industry since 1934