Installation Guide

Page 32 of 36 versatile™ 4C Installation Manual -- 206362 -- Rev A
www.orencemailboxes.com
1 .
Make sure the hopper door is in the upright closed position and the collection door is open.
Close the master door.
2 .
Push up on the hopper from underneath to lift it into the operating position, and let it rotate
forward.
• Both the hopper and hopper door should open.
3 .
Align the hopper handle with the handle holes through the hopper and hopper door, and
install two (2) 1/4-20 x 3/4” one-way screws (65884) through the holes into the handle.
(Loosely tighten only, at this time.)
4 .
With the hopper open, install three (3) #10-32 x 0.375” flat head Phillips screws (65887)
through the hopper bottom and the bottom of the hopper door and secure using three (3)
#10-32 thin lock nuts (86455). (Loosely tighten only, at this time.)
5 .
Verify that the hopper door opens and closes freely.
• The hopper door should close by itself from the open position when the handle is
released. (Adjust as necessary.)
6 .
Tighten all screws and nuts from Steps 3 and 4.
INSTALLATION OF COLLECTION BOX
HOPPER DOOR HANDLE
versatile™ 4C mailbox suites