MOTION ACTIVATED SPRING NECK KITCHEN FAUCET OWNER’S MANUAL
TABLE OF CONTENTS Product Information....................................4 Product Diagram..........................................5 Parts....................................................................6 Recommended Tools..................................7 Installation Types..........................................8 Note Before Installing.................................9 Installation......................................................10 Troubleshooting Guide............................
PRODUCT INFORMATION PRODUCT DIAGRAM Information produit Diagramme de produit Product Features • • • • • • • Metal lever handle 2 function spray head Single-hole or 3-hole installation Drip-free ceramic cartridge 1.
PARTS RECOMMENDED TOOLS (NOT INCLUDED) Les Pièces OUTILS RECOMMANDÉS (Non Inclus) Spray Head Tête de pulvérisation Faucet Robinet • • • • • • Adjustable Wrench Safety Goggles Screwdriver Silicone Sealant Drill 4 AA Batteries • • • • • • Clé à molette Lunettes de sécurité Tournevis Mastic silicone Percer 4 piles AA Counter Weight Contrepoids MAINTENANCE Entretien Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft cloth.
INSTALLATION TYPES NOTE BEFORE INSTALLING Types d’installation Remarque Avant L’installation SINGLE HOLE INSTALLATION Installer Avec Un Orifice This product includes a safety clip. The safety plug must be removed when switching between motion activated and manual operation. Normal Operating Condition Ce produit comprend un clip de sécurité. La sécurité la prise doit être retirée lors de la commutation entre le mouvement activé et opération manuelle.
INSTALLATION Installation NOTE: Flush water lines before installation to release built up impurities in water supply. REMARQUE: Rincez les conduites d’eau avant l’installation pour libérer les impuretés accumulées dans l’alimentation en eau. Step 1 for 1-hole sink Step 1 for 3-hole sink Step 2.1 Step 2.2 Insert the O-ring over the hoses, cable, and stem which are located at the bottom of the faucet. Then mount the faucet onto the sink.
INSTALLATION (CONT.) Installation (suite) 250mm(9.8in) 450mm(17 .7in ) Outle t connection Raccor t de sortie Step 3 Step 4 Step 5.1 Step 5.2 The preferred mounting distance between the spray hose and the control box is 9.8” (250mm). The preferred mounting distance from control box to the floor is 17.7” (450mm). Mount the control box under the sink using a philips head screwdriver according to the preferred dimensions. Make sure to leave some room to adjust.
INSTALLATION (CONT.) Installation (suite) Weight location label Étiquette d'emplacement de poids Step 6.1 Step 6.2 Step 7 Step 8 Connect the data cables and secure them tightly by hand. Tie the data cables together with the outlet hose using a zip tie. Do not include the pull down hose in the zip tie. Install the counterweight on the pull down hose at the marked position (it should be placed on the line). Remove the battery pack cover and battery pack. Insert 4 AA batteries.
INSTALLATION (CONT.) Installation (suite) Step 9 Étape 9 Step 10 Étape 10 Connect the hot and cold supply lines onto the matching water valves and secure the connection with an adjustable wrench. Branchez les lignes d’alimentation chaude et froide sur le robinets d’eau correspondants et sécuriser la connexion avec une clé à molette. Turn on the water supply. Ouvrez l’alimentation en eau.
INSTALLATION (CONT.) Installation (suite) CAUTION: RISK OF PROPERTY DAMAGE! Do not over tighten connections. This will prevent water leakage. NOTICE: Uses care to avoid cross threading or over tightening the connections. Unless otherwise indicated, use an adjustable wrench to tighten one-quarter turn past hand-tight. • Immediately check for any leaks • Continue to check for leaking throughout the first hour of installation. • If leaking occurs, turn off water supply and discontinue use immediately.
INSTALLATION (CONT.) Installation (suite) Step 12 Étape 12 Step 13 Step 14 Open the faucet handle and wave your hand over the sensor. Set the water temperature to desired setting. The water temperature changes by manipulating the handle. Run the water and it will stop automatically in 3 minutes. Check for leaks. Ouvrez la poignée du robinet et agitez votre main sur le capteur. Réglez la température de l’eau au réglage souhaité. La température de l’eau change en manipulant la poignée.
INSTALLATION (CONT.) Installation (suite) Screen filter Filtre d'écran Step 15.1 Étape 15.1 Step 15.2 Étape 15.2 If the water flow rate is lower than normal, there may be build up on the screen filter. Shut off the water valves, remove the outlet hose from the control box, and unscrew the inlet adapter from the control box. Take out the screen filter and clean it. Reassemble the outlet hose connector, inlet adapter, and screen filter.
TROUBLESHOOTING GUIDE Guide de dépannage Condition Possible Cause Solution Condition Possible Cause Solution Water doesn’t flow from the faucet when activated by the infrared sensor. Connections my not be properly made. Use the instruction document to verify all connections were properly made. This will ensure water will flow correctly inside the faucet. Water flow is diminished Faucet handle is not open fully. Filters may have debris. Water shut off valves are not open.
TROUBLESHOOTING GUIDE Guide de dépannage État Cause possible Solution État Cause possible Solution L’eau ne coule pas du robinet lorsqu’il est activé par le capteur infrarouge. Les connexions peuvent ne pas être correctement effectuées. Utilisez le document d’instructions pour vérifier toutes les connexions ont été correctement effectuées. Cette garantira que l’eau s’écoulera correctement à l’intérieur le robinet. De l’eau coule du robinet.
5 YEAR WARRANTY GARANTIE 5 ANS 100% Coverage on all parts and labor for the entire product for all five years from original date of purchase. Our obligations under this warranty are limited to repair or replacement, at our option, of products or parts found to be defective, provided that such products were properly installed and used in accordance with instructions. BBC Innovation LLC reserves the right to make such inspections as may be necessary in order to determine the cause of the defect.
5 YEAR WARRANTY GARANTIE 5 ANS Couverture à 100% sur toutes les pièces et main-d’œuvre pour l’ensemble du produit pendant les cinq années à compter de la date d’achat d’origine. Nos obligations en vertu de cette garantie se limitent à la réparation ou au remplacement, à notre choix, des produits ou des pièces jugés défectueux, à condition que ces produits aient été correctement installés et utilisés conformément aux instructions.
Thank You Technical Support/Customer Service 7900 S Route 31 Crystal Lake, IL 60014 T. 847.458.2334 U.S Toll Free: 877.339.5214 support@biobidet.com biobidet.
