Instructions / Assembly

DOMEHOUSE CLEAR™
ASSEMBLY INSTRUCTIONS & TIE DOWN DIAGRAM
Step 1: Unpack DomeHouse Clear™ and accessories.
Step 2: Take fiber poles out of pack and assemble completely.
Step 3: Grab center of any hub and pull outwards until the wall “pops” out. Repeat at each hub
around the DomeHouse™ until all the walls are “popped” out.
Step 4: Insert shortest support poles into pockets on both sides of doorway.
Step 5: One at a time, place one end of longer support poles into pocket sewn on bottom of wall,
bend up and follow across the interior ceiling arch and back down, placing other end of
pole into pocket sewn into opposing side.
Step 6: Repeat step 5 with remaining longer poles. One will be slightly shorter, that goes from
pocket on top of door to the floor pocket opposite floor. Close Velcro straps around
poles to secure them into place. All the longest poles should cross at peak of
DomeHouse™.
Step 7: Stake and/or weigh down DomeHouse Clear™ in place along bottom skirting. Install high
wind tie downs along the exterior convex points and stake to ground. Enjoy!