Owners manual

3) Place a supplied 3” clamp over the inlet of the muffler, then slide the
inlet of muffler onto the back of the inlet pipe. Use a stand to support the
muffler. Tighten the clamp just enough to hold in position.
4) Slide rubber hanger #HA168 onto the end of 226HA, then using the
supplied bolts, washers, nuts and backing plates #HA566, mount the
assembly to the frame on the left side of the vehicle using the angled oblong
hole on the frame rail. Note: the backing plates #HA566 go on both sides of
the frame between the hanger, washers & bolts to cover the oblong holes so
that the frame hangers won’t bend into the oblong holes.
5) Place two of the supplied 2-1/2” clamps over the right and left outlets
of the muffler. Place right tailpipe #86095S into position over the rear axle,
and slide into the right muffler outlet. Connect the two hangers on the pipe to
the rubber mounts on the vehicle. Pipe should be approximately 3/4” away
from the shock when adjusted.
6) Place left front tailpipe section #86094S into position over the rear axle
and slide into the left muffler outlet. Place a supplied 2-1/2” clamp onto the
back of the pipe. Place left rear tailpipe section #86096S onto the front
section, and connect the hanger welded to the rear of the pipe into the rubber
hanger installed in step 3 above. Pipe should be centered between the shock
and the spare tire when adjusted. Tighten the clamps just enough to hold in
position.
7) Slide the side exit pipes #86097S or the rear exit pipes #86098S onto
the ends of both over axle pipes and place a supplied 2-1/2” clamp onto these
slip-fit connections. Tighten just enough to hold in position. Place the two
stainless tips #ST461 onto the exit pipes and tighten them enough to hold
position. Rotate the exit pipes and tips to the desired distance from the body
or bumper, so that the angle cut on the tips are in the desired location.
8) Adjust the position of all pipes and muffler to provide a satisfactory fit. A minimum 3/4”
clearance around all parts of the system must be maintained; while also keeping suspension travel
and vibration in mind.
9) Tighten all clamped connections down securely. Place the supplied 1/2” hanger keepers onto
the end of the inlet pipe and tailpipe hangers. Slide the 7/16” hanger keeper onto the left rear frame
hanger up to the rubber mounts, to firmly hold the system in place.
10) To prevent the rear axle breather tube from contacting the left side tailpipe, and possibly being
damaged, use the enclosed zip tie to fasten the breather tube to the brake line bracket located on the
rear end. Be sure to allow hose enough slack for the suspension to fully compress and extend.
Pg 2 of 4 Technical Support [phone]