User Manual
Fluance RT80/RT81 User Manual
15
Troubleshooting
Turntable Not Spinning
• The turntable should be connected to a known good power outlet and the power
cable should be securely inserted into the unit.
• Remove the turntable mat and rotate the platter until the motor pulley is visible.
Ensure the rubber belt is intact and hooked around the motor pulley.
• Turn the speed selection knob to 33 or 45 (power led should light up). Lift the
tonearm over the platter and it should start spinning.
No Power
• The turntable should be connected to a known good power outlet and the power
cable should be securely inserted into the unit.
• The power LED should light up when the speed selection knob is set to 33 or 45.
Wrong Speed
1. Check the record label for the correct playback speed and that the speed selection
knob is set to match it. Normal LP playback speed is 33 1/3 rpm.
2. Ensure the turntable 24 hour burn-in process has been completed.
3. If incorrect speed persists a speed adjustment video is available at:
www.uance.com/resources
Skipping
• Ensure the record surface is clear of dirt and debris. Also check that the record is not
warped or deformed.
• Inspect the stylus for built up dirt or debris. Use a stylus cleaning brush to clean if
necessary.
• Ensure the turntable is on a sturdy and level surface.
• Useinstructionsinstepfourofthersttimesetupinstructionstoconrmthe
tonearm was balanced correctly and set to the correct tracking force of 2.0 Grams.
• Check that the anti-skating control is set to 2.