Install Instructions

CLOSED-END
NUT
BRASS
WASHER
TOILET BOWL
SCREW
DO NOT USE:
INSTALLATION INSTRUCTIONS
:DEDEEN SLOOT
For toilet base with four holes, screws are used in the front
two holes.
1. Line up toilet bowl base. Through front two holes on base,
carefully drill 3/16" pilot/starter holes in floor.
2. Insert screws. Place brass washers, then closed-end nuts
over screws.
3. Tighten nuts carefully with wrench. DO NOT OVERTIGHTEN
or bowl may crack.
For toilet base with four holes, toilet bowl bolts are used in the
back two holes to secure bowl to floor flange (use Fluidmaster
Model 7111). If new bolt caps are needed, use Fluidmaster
Model 7115 or 7116.
30800 Rancho Viejo Road
San Juan Capistrano, CA 92675 U.S.A.
www.xthistoilet.com
®
© 2011 Fluidmaster, Inc. All rights reserved. This document is not a substitute for the product
instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be
liable for any damages resulting from failure to install or maintain the product in accordance
with the product instructions, from abuse or misuse of the product, from use of
non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl
cleaners containing bleach or chlorine.