Installation Guide

30800 Rancho Viejo Road, San Juan Capistrano, CA 92675
www.Fluidmaster.com • 800-631-2011
Contact Fluidmaster for troubleshooting help or visit www.fluidmaster.com
M-F 5:30 am - 5:00 pm PST.
Troubleshooting
· See website for Tech Support (www.Fluidmaster.com) or call
800-631-2011, M-F 5:30am - 5:00pm PST
· For best results, clean toilet bowl (including under the rim) before
installation.
· If toilet doesn’t flush or shut off: Make sure the cartridge holder
and tubing aren’t in the way of flushing components.
· If the toilet bowl’s water level is low: Check tubing for kinks.
Installation Tips
· To prevent leaks, make sure the “In” and “Out” tubes are fully
pushed in to their respective ports.
· Make sure the cartridge is tightened down so the “O” ring can fully
engage and seal.
· To prevent leaks, make sure the clip fastener holding the “Out”
tube is secure and that water is flowing directly into the overflow
pipe.
· Do a test flush to make sure components are working properly
before you put the tank lid back on.
WrongRight
Cartridge
1. If necessary, remove cartridge from pouch using scissors. Make sure “O” ring is secure in the
top groove of the cartridge.
2. Insert cartridge into cartridge holder. Turn clockwise ¼ turn to
lock in place.
3. Use extreme care when handling bleach cartridge. Avoid skin
contact. When removing old cartridge, avoid dripping by putting
old cartridge immediately in plastic bag.
Installation
1. Hang the cartridge holder inside the tank. See valve assembly illustrations to determine
position.
2. Remove existing tube from valve port. Replace it with the short tube connected to the “In”
port.
3. Attach clip fastener to the top of the overflow pipe in the center of the tank. Make sure that
the clip fastener is positioned so that the water from the “Out” tube is directed down the
overflow pipe.
1
2
3
“Out”
port
“In” port
Long “out”
tube
Valve port
Flush
valve
Cartridge
holder
Clip
fastener
Fill
valve
Replaceable
cartridge
Mounting
bracket
Overflow
pipe
Short
“in” tube
“Out”
port
“In” port
Long “out”
tube
Valve port
Flush
valve
Cartridge
holder
Clip
fastener
Fill
valve
Replaceable
cartridge
Mounting
bracket
Overflow
pipe
Short
“in” tube
Float cup valve assembly Rod & float valve assembly
Getting Started
For best results, clean toilet bowl (including under the rim) before installation. When you open your toilet tank, you will see either a float cup
valve assembly or a rod and float valve assembly (illustrations below). The type of valve assembly you have will determine where you hang
Flush ‘n Sparkle inside the tank. If this is the first time you have ever installed a device on your toilet, don’t worry, it is very simple and only
takes a minute.
Easy Instructions
®
PART# 12-285, Grev. 4, 11/13