User's Manual

32
5. Write down the unit configuration (at least network settings and wire- less settings);
6. Upgrade the device with the chosen firmware;
7. Once the upgrade is completed, wait for the system to reboot.
WARNING: DO NOT RESTART OR POWER OFF THE UNIT WHILE UPGRADING THE
FIRMWARE. RESTARTING OR POWERING OFF THE UNIT BEFORE THE UPGRADE
IS COMPLETED MIGHT DAMAGE THE UNIT.
When the upgrade is completed, check the firmware upgrade page in order to make sure that the
new firmware version has been correctly up-dated. If the firmware version has not been changed,
the upgrade process has failed. Therefore, please repeat the upgrade procedure.
Figure 7.17: Firmware Upgrade Web Page
7.15 Plug-In Management
The manage plug-ins page (Figure 7.17) shows the installed Plug-ins and allows the user to
add Plug-in Activation Codes. Additionally, a Plug-in can be deactivated to, for example, transfer
it from one unit to another. Once the Plug-in has been deactivated, you will be provided with a
Deactivation Code displayed at the bottom of the page. In order to get a fresh Activation Code to
use it in another device, you must complete the unit deactivation procedure at the Fluidmesh
Networks website (www.fluidmesh.com). Please refer to Section 6 for details on the software
Plug-in activation/deactivation procedures.
Please check the license code activation video by clicking on the link below. Please note, you need to