User's Manual

Vibration Meter
About Measurements
27
How to Recall a Setup for Measurements
You can recall a Setup file from memory for frequent
measurements done on the same machine. A Setup file
saves time when the parameter selection is already done
and stored to memory.
To recall a Setup from memory:
1. Push  to open the MEMORY screen.
2. Push  and  to highlight View Setups.
3. Push  to opens the VIEW SETUPS
screen with three sorting options:
• by Name: shows a list of machine setups by
machine ID in alphabetical sequence.
• by Category: shows a list of machine setups
by Machine Category in alphabetical
sequence.
• Last Used: shows the last used machine ID.
4. Push  and  to highlight an option.
5. Push  to open the list of setups.
6. Push  and  to highlight a setup.
7. Push  to open the setup record.
8. Push .
Note
Push  before you apply the Meter to the test
surface.
9. Push Meter onto test surface until the green LED
turns on.
10. Wait until the green LED turns off.
The Measurement screen shows the selected
Setup with machine ID in the ID field.
gqi81.jpg
11. When measurement is complete, push .
12. Push  and  to highlight Save To Current
Setup.
13. Push  to save the measurement to the
setup.
To recall a measurement, see View All Data on
page 28.