User's Manual

Tag Configuration
Table 2. Network Settings Available for Beacon100
Setting Description Values Available in Activator
Wireless network settings:
SSID, Encryption, Key and
Key Index
Use exactly 5 or 13
characters (or hex bytes) for
40/104 bit encryption keys
SSID=max 32 digits,
Encryption=no; WEP 40;
104bit
Note that WPA is not
supported with this
firmware
Yes
SSID 1
Second wireless network
settings: SSID, Encryption,
Key and Key Index
Use exactly 5 or 13
characters (or hex bytes) for
40/104 bit encryption keys
SSID=max 32 digits,
Encryption=no; WEP 40;
104bit
Note that WPA is not
supported with this
firmware
No
SSID 2
Selection of channels that are
scanned.
To conserve battery, select
only the channels in use
Check boxes for
selecting scanned
channels from 1 to 14
Note the channel
restrictions depending on
operating region
Yes
Scan Channels
IP method Defines the IP address
assigning method
DHCP, static or network
wide DHCP
1
Yes (DHCP or static)
IP address Beacon100 IP address if
static addressing is used
Beacon100 IP address Yes
IP netmask Beacon100 netmask when
static addressing is used
Beacon100 netmask Yes
IP gateway IP network gateway when
static addressing is used
Network gateway Yes
Positioning Engine
IP address
IP Address of Positioning
Engine
IP Address Yes
Engine Port Port number of Positioning
Engine location protocol port
Port number. Default port
is 8552
Yes
Port number of Positioning
Engine maintenance port
Port number
Default port is 8553
Yes
Positioning
Management UDP
port
[1]
Network wide DHCP enables roaming between sub networks. With this setting, the Beacon100 tag
refreshes its IP address whenever the tag associates with a new access point. It is not recommended to use
the feature if it not required, due to higher power consumption.
Wake-up Settings
The list of other settings is shown in Table 3.
5