User's Manual

Technical Specifications

Operating Ranges from Access Point

Open Space: 60m (180ft)

Typical Office: 30m (90ft)

Battery Replacement

Replace the batteries by opening the four screws on the backside of the tag. Remove old

batteries from the device by pulling them gently upwards. Place each new battery

between the battery clips.

Note

When replacing the batteries, take out one first and replace, and only after

that replace the other second battery. This way the tag maintains its

settings.

Check that the polarity of the batteries is correct. There are battery polarity indicators on

the circuit board and inner surface of the front cover. The correct polarity is also shown

in Figure 2. When replacing batteries, avoid touching the circuit board and the flex cable,

which can be damaged by static electricity or mechanical impact.

fig_2.emf

Figure 2. Battery Polarity and Replacement

Recommendations for choosing and replacing batteries include the following:

• Always use new batteries

• Replace the batteries together, removing and replacing first one, then the other

• Use only 3.0V, CR2 size batteries

• Fluke Biomedical recommends batteries from Durecell, Maxell, Sanyo or

VARTA

After batteries have been replaced close the back cover, replace and tighten the screws.