User Manual
Table Of Contents
- Table of Contents
- Introduction
- Comprehensive Integration Instructions for Fluke FBLE radio module
- Interface to external Microprocessor
- Physical Interface
- Software Interface
- Network Command Communication
- Device Command Communication
- Device Notification Communication
- SPI Data Packets
- SPI Packet Formats
- SPI Packet Field Definitions
- SPI Packets are Big-Endian
- Network Control Commands
- Network Control Commands
- Device Control Command Payloads
- Device Control Command Responses
- Interrupt Status Word
- Network Control Commands and Responses are Big-Endian
- BLE Custom UUID
- Firmware Upgrade over BLE
- External processor upgrade over BLE
Fluke Corporation Telephone Facsimile Email
PO Box 9090 Everett WA 98206.9090 USA 425.347.6100 425.356.5108 http//www.fluke.com
• Force Drop - Writing anything to this item causes the BLE module to drop. This is a
work around for Apple related issues, per Brady H.
3.6. 0x2905 : Set Locator State
• CC254x Module: Active as of 00.00.05
• Set Locator State - write only uint8, 0 to turn off locator, 1 to turn on locator.
3.7. 0x2906 : IG Logging Status
• CC254x Module: Active as of 00.00.06
• IG Logging Status - read only uint8 array, 9 bytes.
•
o
Logging Status Data Description
Field
Logging State
Log - Total Bytes
Log - Used Bytes
Size in
bytes
1
4
4
Description
Logging state enum:
0:Idle, 1:Logging,
2:Not Supported
unsigned integer,
total number of bytes
for logging in bytes.
unsigned integer,
used bytes for
logging in bytes
3.8. 0x2907 : IG Logging Settings
• CC254x Module: Active as of 00.00.06
• IG Logging Settings - read / write uint8 array, 9 bytes.
•
o
Logging Settings Data Description
Field
Log - Interval
Log - Duration
Size in
bytes
4
4
Description
unsigned integer, logging
interval in seconds
unsigned integer, logging
duration in seconds
3.9. 0x2908 : IG Logging Control point
• CC254x Module: Active as of 00.00.07
• IG Logging Control point.