User Manual
Table Of Contents
- Table of Contents
- Introduction
- Comprehensive Integration Instructions for Fluke FBLE radio module
- Interface to external Microprocessor
- Physical Interface
- Software Interface
- Network Command Communication
- Device Command Communication
- Device Notification Communication
- SPI Data Packets
- SPI Packet Formats
- SPI Packet Field Definitions
- SPI Packets are Big-Endian
- Network Control Commands
- Network Control Commands
- Device Control Command Payloads
- Device Control Command Responses
- Interrupt Status Word
- Network Control Commands and Responses are Big-Endian
- BLE Custom UUID
- Firmware Upgrade over BLE
- External processor upgrade over BLE
Fluke Corporation Telephone Facsimile Email
PO Box 9090 Everett WA 98206.9090 USA 425.347.6100 425.356.5108 http//www.fluke.com
0x09
CNX_FW_CP_STATE_ERROR
0x0a
CNX_FW_CP_STATE_BUFFER_FILLING
0x0b
CNX_FW_CP_STATE_SWAP_FAIL
0x0c
CNX_FW_CP_STATE_RADIO_INIT_QUERY
0x0d
CNX_FW_CP_STATE_RADIO_INIT_OFF
0x0e
CNX_FW_CP_STATE_RADIO_INIT_ON
0x0f
CNX_FW_CP_STATE_RADIO_INIT_CHANGING
Valu
e
Command
Note
0x80
CNX_FW_CP_CMD_ERASE_MEM
Erase the Flash
Memory on the
MSP430
0x81
CNX_FW_CP_CMD_CLEAR_BUF
Clear the
FW_UPDATE_BUF in
the radio
0x82
CNX_FW_CP_CMD_WRITE_AND_CLEAR_
BUF
Write the contents of
the
FW_UPDATE_BUF to
the MSP430, then clear
the
FW_UPDATE_BUF
0x83
CNX_FW_CP_CMD_DO_VERIFY
Cause the MSP430 to
verify the local copy of
the new firmware
0x84
CNX_FW_CP_CMD_DO_SWAP
Load the new
Firmware into the
MSP430 (requires a
verify to pass first)
0x85
CNX_FW_CP_CMD_RADIO_INIT_ON
Change device settings
to turn on the radio at
power up.
0x86
CNX_FW_CP_CMD_RADIO_INIT_OFF
Change device settings
to keep the radio off at
power up.