User's Manual

TiS10, TiS20, TiS40, TiS45, TiS50, TiS55, TiS60, TiS65
Users Manual
32
6. Push Y/Z to highlight hours or minutes.
The 12 hour format has a selection to set the time as
AM or PM.
7. Push
W or X to change the setting.
8. Push  to set the change.
Language
To change the display to a different language:
1. Go to Settings > Language.
2. Push
W or X to highlight the setting.
3. Push  to set a new language.
b
Wireless Connectivity
The Imager is equipped with WiFi, Bluetooth, and
Bluetooth Low Energy wireless connectivity options.
Wireless connectivity enhances your ability to work more
efficiently and better communicate results. The Imager
ships with the radio disabled. For first-time use, you must
enable the radio to use wireless connectivity.
To enable the radio:
1. Connect the Imager to a PC with internet access and
Fluke SmartView software.
SmartView detects that the radio is disabled in the
Imager and prompts you to register at www.fluke.com
and enable the radio.
2. When you opt in, SmartView opens up a browser
window to the Fluke registration web page. The web
page provides the Imager serial number, choice of
radio, and UI language.
3. Type the registration information into the web page.
The server checks if the radio can be enabled for this
address. If yes, a passphrase is provided to paste into
SmartView.
SmartView validates that the passphrase is correct and
then enables the radio in the Imager.

Bluetooth
®
Bluetooth
®
technology is available to connect a wireless
headset to the Imager. When on,
 shows on the display
(upper left corner).

WiFi™ Hotspot
Note
WiFi is for indoor use only in Kuwait, Chile, and
United Arab Emirates.
You can wirelessly send a picture from the Imager to a PC,
an iPhone, and an iPad through the WiFi connection. A
transferred image can be viewed with Fluke Connect™ or
SmartView Analysis and Reporting software if installed in
the device.