User Guide
Table Of Contents
- CableIQ Getting Started Guide
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Accessing the Users Manual
- Safety
- Controls
- Setting User Preferences
- Editing Text
- Connecting for Cabling Tests
- Results Icons
- Discovering Cabling Characteristics
- Qualifying Cabling with the Autotest
- Using the Toner
- Blinking a Port Light
- Testing for Continuity
- Using the Continuity Toner
- Locating Crosstalk and Impedance Faults
- Testing Speaker Cabling
- Replacing the Batteries
- Contacting Fluke Networks
CableIQ Getting Started Guide
8
Discover Mode with MultiMap
Verifies wiremaps of multiple telephone outlets
connected in a star or bus topology.
AXY07
Qualifying Cabling with the Autotest
The Autotest tells you if cabling will support a selected
application. You can save Autotest results to
document an installation.
Connect to the cabling as shown on pages 3 and 4.
Turn the rotary switch to AUTOTEST. To select tests
and pairs to test, press
Setup. To start the test,
press .
Note
The Autotest does not support use of
multiple remote ID locators (the MultiMap
function).
To save the test, press . You can enter a Site
name, Location, and Outlet to identify the results. The
last character of the Outlet string increments each
time you save an Autotest.