User Manual

CableIQ Qualification Tester
Users Manual
72
Performance Specifications (cont.)
Tone generator Generates digital tones compatible with Fluke Networks IntelliTone probe and 4 tones
compatible with typical analog probes (all pairs, frequency 1-2 kHz).
Continuity test Resistance range: 0 Ω to 10,000 Ω
Tone generation: Variable tone between 500 Ω and 5,000 Ω. Tone is audible and can also
be detected by a tone probe.
Speaker test tone
generator
Variable frequency with left and right speaker and polarity control.
Crosstalk and impedance
fault diagnostics
Identifies distributed and localized crosstalk and impedance faults on twisted pair cabling.
Minimum and maximum lengths (using default NVP values):
Twisted pair: 3.4 m to 210.1 m (11.0 ft to 689.2 ft)
Coaxial: 3.9 m to 246.0 m (12.9 ft to 807.4 ft)
Regulatory Information
This equipment generates, uses, and can radiate radio
frequency energy, and, if not installed and used in
accordance with the manual, may cause interference to
radio communications. It has been tested and found to
comply with the limits for a Class A digital device
pursuant to Part 15, Subpart J of the FCC rules, which are
designed to provide reasonable protection against such
interference when operated in a commercial
environment. Operation of the equipment in a
residential area is likely to cause interference, in which
case the user, at his own expense, will be required to
take whatever measures may be required to correct the
interference.