Operation Manual

Set Up the Tester

To change settings on the tester, select Tools from the home

screen.

ffy23.bmp

Figure 4. Tools Menu

IP Configuration

Select Tools > IP Configuration.

ffy40.bmp

Figure 5. IP Configuration Screen

This screen allows you to enter an IPv4 address or use a

DHCP address (default). It also allows you to enable IPv6

addressing (LR-AT 2000 only). LR-AT uses the IP address

during AutoTest. During AutoTest, the LR-AT is required to

connect to the network for Ping and TCP Connectivity

testing.

At no other time, does the LR-AT connect to the network

using IP addressing. This applies to the Switch and Cable

test screens.