User Manual

IntelliTone Pro
Users Manual
4
Battery Status
LEDs on the toner and probe light for 1 second at power
on to indicate the battery status:
Green: Battery is good.
Yellow: Battery is marginal.
Red: Battery is low.
See “Battery Life and Replacement” on page 16 for more
information on the battery.
Auto Power Down
The toner turns off automatically after approximately 2 ½
hours of inactivity. The probe turns off automatically after
1 hour of inactivity.
To reactivate the toner or probe, turn the rotary switch to
any position except OFF.
Locating and Isolating Terminated
UTP/STP Cables with the IntelliTone
The IntelliTone Pro toner provides two toning modes for
locating and isolating cables; one digital tone
 and
one SmartTone 1kHz analog tone .
With the toner set to digital tone mode, the probe can be
set to either locate
 or isolate .
Both toning signals are available at all connectors on the
toner.
The digital tone
 is optimized for 4 pair UTP data
environments and the SmartTone analog tone  is
optimized for two wire locating.
To locate and isolate cables using the digital tone, do the
following:
1 Connect the IT200 toner to a jack or punch-down block
as shown in Figure 1.
2 Turn the toner’s rotary switch to .
3 Turn the IP200 probe’s rotary switch to  (locate).
4 Use the probe to find the general location of the tone
at a cable rack, patch panel, or behind a wall. The
SYNC LED lights up green when the probe is receiving
the IntelliTone signal.
Toner battery status
LED
Probe battery status
LED