User Manual
Table Of Contents
- IntelliTone Pro Users Manual
- LIMITED WARRANTY AND LIMITATION OF LIABILITY
- Contents
- Overview of Features
- Registration
- Contacting Fluke Networks
- Unpacking
- Safety Information
- Battery Status
- Auto Power Down
- Locating and Isolating Terminated UTP/STP Cables with the IntelliTone
- Isolating Individual Wire Pairs with the SmartTone Analog Function
- Validating RJ11 and RJ45 Cable Maps
- Validating the Cable’s Shield
- Validating Ethernet Service
- Testing for Continuity
- Maintenance
- Specifications
Locating and Isolating Terminated UTP/STP Cables with the IntelliTone
5
In locating mode, the probe’s LEDs light up from 1 to 8
as the signal strength increases. The higher the
number, the stronger the signal.
Note
If you cannot locate the IntelliTone signal on 2-
conductor cabl
es, the cable may be shorted. Use
the cable map test (page 8) to test for shorts on
cables with RJ11 and RJ45 connectors. Use the
continui
ty test (page 12) to check for shorts on
coax and non-terminated cables.
5
Turn the probe’s rotary switch to (isolate).
6
Use the probe to isolate the tone source in the cable
bundle or at the patch panel. The SYNC LED lights up
green when the probe is receiving the IntelliTone
signal.
In isolating mode, the probes LEDs light up from 1 to 8 as
the signal strength increases.