Operation Manual

Versiv Cabling Certification Product Family
Users Manual
126
 The round icon shows the number of splices entered for the
SPLICES setting on the No. of Connectors/Splices screen.
 Bi-directional results show the fibers crossed at the main and
remote ports. The fibers show the connections as they are at the
end of the test.
 To see help for the screen, tap .
 When more than one button shows at the bottom of the screen,
the tester highlights one in yellow to recommend which one to
tap. See “Buttons to Do Tests and Save Results” on page 18.
Autotest in Loopback Mode
Use Loopback mode to do tests on spools of cable and segments
of uninstalled cable.
In this mode, the tester measures loss and length at two
wavelengths. If you turn on the Bi-Directional function and swap
the fibers halfway through the test, the tester makes
measurements in both directions.
Figure 46 shows the equipment for tests in Loopback Mode.