Operation Manual

Chapter 7: Use the OTDR
The OptiFiber Pro Home Screen
151
: The number of tests that passed.
: The number of tests that failed.
 The test setup panel shows the settings the tester will use
when you tap TEST or press .
To change these settings, tap the panel, select the test on the
CHANGE TEST screen, tap EDIT, select different settings on the
TEST SETUP screen, then tap SAVE.
Note
You can set up tests for any module that the
tester can use, even when no module is attached.
 Next ID: The Next ID panel shows the ID that the tester gives
to the next test results you save.
Tap Next ID to do these tasks:
 Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
 Turn Auto Save on or off.
 Select End 1 or End 2 for OTDR and FiberInspector tests.
 Enter a name for End 1 and End 2.
 Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names. For each operator you
can also enter the email address that the operator will use as an
ID to sign in to LinkWare Live.
 TOOLS: The TOOLS menu lets you set up the compensation
function for the launch/tail cords, use tools such as the real-
time trace and the FiberInspector test, see the status of the
tester, and set user preferences such as the language and the
display brightness.
 RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.