Operation Manual

Chapter 2: Certify Twisted Pair Cabling
The DSX CableAnalyzer Home Screen
35
 Shows a summary of the test results in the project:
: The number of tests that passed.
: The number of tests that failed.
: The number of tests with an overall marginal result.
 The test setup panel shows the settings the tester will use
when you tap TEST or press . To change these settings,
tap the panel.
Note
You can set up tests for any module that the
tester can use, even when no module is attached.
 Icons show the status of the Store Plot Data and AC Wire Map
settings. See Table 2 on page 40.
 Next ID: The Next ID panel shows the ID that the tester gives
to the next test results you save.
Tap Next ID to do these tasks:
 Enter an ID, select a different ID in the ID set, select a
different set of IDs, or make a new set. The tester adds the
IDs and ID sets you make to the project that shows on the
home screen.
 Turn Auto Save on or off.
 Operator: The name of the person who does the job. You can
enter a maximum of 20 operator names. For each operator you
can also enter the email address that the operator will use as an
ID to sign in to LinkWare Live.
 TOOLS: The TOOLS menu lets you set the reference, see the
status of the tester, and set user preferences such as the
language and the display brightness.
 RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
 TEST: Tap TEST to do the test shown in the test setup panel.