Operation Manual

Versiv Cabling Certification Product Family

Users Manual

 The percentage of the project that is completed. The

percentage is the number of IDs used for saved results divided

by the total number of used and available IDs in the project.

The number of IDs includes IDs for copper and fiber cable.

% Tested does not show if your project contains only a Next ID

list. See “About Next ID Sets” on page 217 for more information

about the Next ID list.

 The type of module attached to the main Versiv unit.

 This icon shows when the tester’s link interface adapter

is connected to the adapter on a Versiv remote and the

remote is turned on.

 This icon shows when the talk function is on. To use the

talk function:

1 Connect the main and remote testers together through a

link that has one or more good wire pairs.

2 Connect headsets to the headset jacks on the testers.

3 Press the button on one of the headset microphones or

press  on the remote, then speak into the

microphone.

Make Sure Your Tester is Ready to Certify

Cabling

To make sure your tester meets its accuracy specifications, follow

these guidelines:

 Keep the tester’s software current. The latest software is

available on the Fluke Networks website. See “Update the

Software” on page 235.

 Set the reference for the twisted pair adapters every 30 days.

See page 37.

 Make sure that you select the correct cable type for the job,

and that the NVP for the cable is correct. See Table 2 on

page 39.