User's Manual

5-1
Chapter 5
Calibration Adjustment
Title Page
5.1 General ........................................................................................................ 5-3
5.1.1 Introduction.......................................................................................... 5-3
5.1.2 Calibration number and date................................................................ 5-3
5.1.3 General Instructions............................................................................. 5-3
5.2 Equipment Required For Calibration.......................................................... 5-4
5.3 Starting Calibration Adjustment ................................................................. 5-4
5.4 Contrast Calibration Adjustment ................................................................ 5-6
5.5 Warming Up & Pre-Calibration.................................................................. 5-7
5.6 Final Calibration ......................................................................................... 5-7
5.6.1 HF Gain Input A&B ............................................................................ 5-7
5.6.2 Delta T Gain, Trigger Delay Time & Pulse Adjust Input A................ 5-9
5.6.3 Pulse Adjust Input A (firmware V01.00 only) .................................... 5-10
5.6.4 Pulse Adjust Input B............................................................................ 5-11
5.6.5 Gain DMM (Gain Volt)....................................................................... 5-11
5.6.6 Volt Zero.............................................................................................. 5-13
5.6.7 Zero Ohm (firmware V01.00 only)...................................................... 5-13
5.6.8 Gain Ohm............................................................................................. 5-14
5.6.9 Capacitance Gain Low and High......................................................... 5-15
5.6.10 Capacitance Clamp & Zero................................................................ 5-15
5.6.11 Capacitance Gain............................................................................... 5-16
5.7 Save Calibration Data and Exit................................................................... 5-16