Data Sheet

2 Fluke Corporation Current clamp set 20 A/200 A 1-, 3-phase and 3-phase+N
Fluke Corporation
PO Box 9090, Everett, WA 98206 U.S.A.
Fluke Europe B.V.
PO Box 1186, 5602 BD
Eindhoven, The Netherlands
For more information call:
In the U.S.A. [phone] or
Fax [phone]
In Europe/M-East/Africa [phone] or
Fax [phone]
In Canada (800)-36-FLUKE or
Fax [phone]
From other countries [phone] or
Fax [phone]
Web access: http://www.fluke.com
©2009 Fluke Corporation.
Specifications subject to change without notice.
Printed in U.S.A. 11/2009 3564620A D-EN-N
Modification of this document is not permitted
without written permission from Fluke Corporation.
Fluke. Keeping your world
up and running.
®
General specifications
Maximum conductor size 15 mm diameter, bus bar 15 mm x 17mm
Cable length 2 m
Operating temperature range -10 °C to +55 °C
Storage temperature range -20 °C to +70 °C
Operating humidity 15 % to 85 % r.h. (non-condensing)
Weight (per clamp) 175 g
Environment temperature range +18 °C to +26 °C
Humidity 20 % to 75 % r.h.
Current Sinusoidal waveform, 48 Hz to 65 Hz, distortion factor: < 1 %, no dc
component
Safety standards IEC/EN61010-1: 2001
IEC/EN61010-2-032:2002
IEC/EN61010-031:2002
EMC standards IEC/EN 61326-1:2006
Safety 600 V CAT III, pollution degree 2
The current clamps are designed for use on insulated conductors. For using it with uninsulated conductors you have to
switch off before attaching the clamp. The application of the clamps on uninsulated conductors is limited to 600 V ac r.m.s.
or dc to ground and frequencies below 1 kHz.
Dimensions (in mm)
Ordering information
3-phase: 3024451 I20/200A Clamp PQ3
3-phase+N: 3024460 I20/200A Clamp PQ4
Symbols
Do not apply around or remove from HAZARDOUS LIVE conductors.
Product is protected by double insulation.
Risk of Danger. Important information. See Instruction Sheet.
Risk of Electric Shock.
Canadian Standards Association has certified that the product meets
applicable U.S. and Canadian Standards.
Conforms to relevant European Union directives.