User's Manual

Manual Supplement 175, 177, & 179 Calibration Information
2 3/13
Change #3, 63224, 63743
On page 3, replace the Symbols table with:
Symbols

AC (Alternating Current)

Fuse

DC (Direct Current)

Conforms to European Union directives.


DC/AC

North America Standards Association

Earth ground

Double insulated

Capacitance

Battery (Low battery when shown on display.)

Risk of Danger. Important information. See Manual.

Continuity test or continuity beeper tone.

Hazardous voltage. Risk of electric shock.

Conforms to relevant Australian standards.

Conforms to relevant South Korean EMC
Standards.

Inspected and licensed by TÜV Product
Services.

This product complies with the WEEE Directive (2002/96/EC) marking requirements. The affixed label indicates
that you must not discard this electrical/electronic product in domestic household waste. Product Category: With
reference to the equipment types in the WEEE Directive Annex I, this product is classed as category 9 "Monitoring
and Control Instrumentation” product. Do not dispose of this product as unsorted municipal waste. Go to Fluke’s
website for recycling information.
CAT II
Measurement Category II is applicable to test and measuring circuits connected directly to utilization points (socket
outlets and similar points) of the low-voltage MAINS installation.
CAT III
Measurement Category III is applicable to test and measuring circuits connected to the distribution part of the
building’s low-voltage MAINS installation.
CAT IV
Measurement Category IV is applicable to test and measuring circuits connected at the source of the building’s low-
voltage MAINS installation.
On page 4, in the Specification section, delete the Surge Protection, Electromagnetic
Compatibility, Safety Compliance, and the Certifications and add:
Safety ............................................................ IEC 61010-1: 600 V CAT IV / 1000 C CAT III, Pollution Degree 2
Electromagnetic Environment ......…. ......... IEC 61326-1: Portable
Electromagnetic Compatibility ................... Applies to use in Korea only Class A Equipment (Industrial
Broadcasting & Communication Equipment)
[1]
[1] This product meets requirements for industrial (Class A)
electromagnetic wave equipment and the seller or user should
take notice of it. This equipment is intended for use in business
environments and is not to be used in homes.
On page 6, add footnote 9, and add to Temperature
9
:
9. In RF field of 3 V/m specified accuracy 5 °C (9 °F).