User's Manual

R e m o t e C o n t r o l a n d P r o g r a m m i n g R e f e r e n c e f o r t h e F L U K E 1 9 0 f a m i l y o f S c o p e M e t e r ® t e s t t o o l s
p a g e 6 2
In the following window click ‘Next’ to install the software
automatically. Windows will then download the drivers from
the Windows Driver Distribution Center on the internet
automatically. If no connection to the internet is available, you
may use the CD-ROM, supplied with the ScopeMeter, which
also contains a version of these drivers.
Follow the instructions on screen. When the driver has
finished installation click ‘Finish’ to complete the first step of
the driver installation.
After completing of the first step, the New Hardware Wizard
will start again, this time to install the USB Serial Port Driver.
Click ‘Next’ to install the software automatically.
Windows will then download the drivers from the Windows
Driver Distribution Center on the internet automatically. If no
connection to the internet is available, you may use the CD-
ROM, supplied with the ScopeMeter, which also contains a
version of these drivers.
Once more, follow the instructions on screen. Once the
installation completes, click ‘Finish’ to complete the final step
of the driver installation.
You are now ready to use the ScopeMeter with FlukeView
Software SW90W from version V5.0 onwards.