Product Manual

Remote Operation
Remote commands17
17-19
FORCETRG Force a trigger to the selected channel.
Will function with any trigger source except
MANUAL specified.
Modulation Commands
MOD <cpd> Set the modulation source to <OFF>, <EXT>
or <PREV>.
MODTYPE <cpd> Set the modulation type to <AM> or <SCM>.
AMDEPTH <nrf> Set the depth for amplitude modulation to
<nrf> %.
SCMLEVEL <nrf> Set the level for SCM to <nrf> volts.
SUM <cpd> Set the sum source to <OFF>, <EXT> or
<PREV>.
SUMRATIO <nrf> Set the sum ratio to <nrf>.
Synchronizing Commands
REFCLK <cpd> Set the
REF CLK IN/OUT to <IN>, <OUT>,
<MASTER> or <SLAVE>.
ABORT Aborts an external phase synchronizing
operation.
PHASE <nrf> Set the generator phase to <nrf> degrees.
This parameter is used for setting the trigger/gate
mode start/stop phase and the phase difference
when synchronizing channels.
LOCKMODE <cpd> Set the channel lock mode to <INDEP>,
<MASTER>, <FTRACK> or <SLAVE>.
LOCKSTAT <cpd> Set the inter-channel synchronization status to
<ON> or <OFF>.
Status Commands
*
CLS Clear status. Clears the Standard Event Status
Register, Query Error Register and Execution
Error Register. This indirectly clears the Status
Byte Register.
*
ESE <nrf> Set the Standard Event Status Enable Register to
the value of <nrf>.
*
ESE? Returns the value in the Standard Event Status
Enable Register in <nr1> numeric format. The
syntax of the response is <nr1><rmt>.
*
ESR? Returns the value in the Standard Event Status
Register in <nr1> numeric format. The
register is then cleared. The syntax of the
response is <nr1><rmt>.