Supplement Title: Part Number: Print Date: Revision/Date: 9062 Users 2438554 April 2005 Supplement Issue: 3 Issue Date: 11/18 Page Count: 6 This supplement contains information necessary to ensure the accuracy of the above Instruction Sheet. © 2013-2018 Fluke Corporation. All rights reserved.
9062 Users Manual Supplement Change #1, 65801, 506, 644 On page 4, add the following Warnings: Use the Product only as specified, or the protection supplied by the Product can be compromised. Do not use the Product around explosive gas, vapor, or in damp or wet environments. On page 5, replace the Recycling Information and the CAT III in the Symbols table: ~ 11/18 This product complies with the WEEE Directive (2002/96/EC) marking requirements.
Manual Supplement 9062 Users On page 5, add the following Symbols: ) Measurement Category II is applicable to test and measuring circuits connected directly to utilization points (socket outlets and similar points) of the low voltage mains installation. Conforms to relevant South Korean EMC Standards.
9062 Users Manual Supplement Determine the Motor Connection: Nominal test Voltage (Ume): 1 V ac to 400 V ac Nominal Test Currents (In per phase): <3.5 mA Frequency Range (fn): 2 Hz to 400 Hz Temperature: Operating -10 C to +40 C Storage -40 C to +60 C Operating Relative Humidity: 15 % to 80 % Altitude Operating ≤2,000 m Storage ≤12,000 m Size: 12.4 cm x 6.1cm x 2.
Manual Supplement 9062 Users Electromagnetic Compatibility: International: IEC 61326-1: Industrial Electromagnetic Environment CISPR 11: Group 1, Class A Group 1: Equipment has intentionally generated and/or uses conductively-coupled radio frequency energy that is necessary for the internal function of the equipment itself.
9062 Users Manual Supplement Class A: Equipment meets requirements for industrial electromagnetic wave equipment and the seller or user should take notice of it. This equipment is intended for use in business environments and not to be used in homes. USA (FCC): 47 CFR 15 subpart B. This product is considered an exempt device per clause 15.103. Change #2, 449, 506 On page 4, add the following Warnings: Use the Product only as specified, or the protection supplied by the Product can be compromised.
Manual Supplement 9062 Users Use Product-approved measurement category (CAT), voltage, and amperage rated accessories (probes, test leads, and adapters) for all measurements. Do not use the Product if it operates incorrectly. Examine the case before you use the Product. Look for cracks or missing plastic. Carefully look at the insulation around the terminals. Use only current probes, test leads, and adapters supplied with the Product. Do not put metal objects into connectors.