Information

ManualsBrandsFLUKE ManualsTest & Measurement114 Digital Multimeter LCD, 6000 counts

Manual Supplement

Manual Title: 114,115 and 117 Users Supplement Issue: 4

Part Number: 2572573 Issue Date: 11/06

Print Date: July 2006 Page Count: 4

Revision/Date:

This supplement contains information

necessary to ensure the accuracy of

the above manual.

Summary of content (5 pages)

PAGE 1
Manual Supplement Manual Title: 114,115 and 117 Users Supplement Issue: 4 Part Number: 2572573 Issue Date: 11/06 Print Date: July 2006 Page Count: 4 Revision/Date: This supplement contains information necessary to ensure the accuracy of the above manual. © 2006 Fluke Corporation. All rights reserved. Printed in the U.S.A.
PAGE 2
114, 115 and 117 Users Manual Supplement Change #1 On page 3, add the following after the last bullet: • Do not use the Auto Volts function to measure voltages in circuits that could be damaged by this function's low input impedance (≅3 kΩ) (114 and 117 only). Change #2 On page 6, replace number A with the following: A 8/06 Input terminal for measuring ac and dc current to 10 A.
PAGE 3
Manual Supplement 114, 115, and 117 Users On page 21, under AC Amps and DC Amps, replace the Range with the following: 6.000 A 10.00 A[3] 20 A overload 30 seconds maximum, 10 minutes rest minimum. Add the following note to the bottom of the table: [3] >10 A unspecified Change #3 On page 18, under General Specifications, replace the first sentence with the following: Accuracy is specified for 1 year after calibration, at operating temperatures of 18 ºC to 28 ºC, with relative humidity at 0 % to 90 %.
PAGE 4
114, 115 and 117 Users Manual Supplement Change #4 On page 19, change the following: From: IP Rating (dust and water protection)….IP52 with no vacuum applied To: IP Rating (dust and water protection)….IP42 Change #5 On page 2, add the following bullet: • 11/06 Only use test leads that have the same voltage, category, and amperage ratings as the meter and that have been approved by a safety agency.
PAGE 5
Manual Supplement 114, 115, and 117 Users Change #6, 39101 On page 20, Table 1, for the Ohms Function, change the 40.00 MΩ Accuracy: From: 1.5.