Instructions

ManualsBrandsFLUKE ManualsTest Equipment345 Mains-analysis device, Mains analyser

Manual Supplement

Manual Title: 345 Users Supplement Issue: 7

Part Number: 2560401 Issue Date: 3/18

Print Date: October 2006 Page Count: 3

Revision/Date:

This supplement contains information

necessary to ensure the accuracy of

the above manual.

Summary of content (4 pages)

PAGE 1
Manual Supplement Manual Title: 345 Users Part Number: 2560401 Print Date: October 2006 Revision/Date: Supplement Issue: 7 Issue Date: 3/18 Page Count: 3 This supplement contains information necessary to ensure the accuracy of the above manual. © 2007-2018 Fluke Corporation. All rights reserved.
PAGE 2
345 Users Manual Supplement Change #1 On page 15, under Voltage Measuring Input, replace the first sentence with the following: The maximum input voltage for over-voltage category CAT IV may not exceed 600 V to earth ground. Change #2 On page 25, under Balanced Three-Phase Power Measurement Connection, replace: Current is measured on one phase and the two voltages are measured on the remaining phase. With: Current is measured on one phase and the phase-to-phase voltage is measured on the remaining lines.
PAGE 3
45 Users Manual Supplement Change #4, 63545 On page 1, add the following to the Symbols table: Ã Conforms to relevant South Korean EMC Standards. ¤ Conforms to CAN/CSA-C22.2 No. 61010-1, second edition, including Amendment 1. Change #5, 65704 On page 11, under General Data: Change: Battery Eliminator BE345 Input……110V / 230V, 50/60 Hz Output….15 V dc, 300 mA To: Battery Eliminator GFP151DA-120125B-1 Input……100 V to 240 V, 50/60 Hz, 0.36 A Output….12 V dc, 1.
PAGE 4
345 Users Manual Supplement Change #6, 66326 On page 1, Table 1, replace CAT with: CAT IV Measurement Category IV is applicable to test and measuring circuits connected at the source of the building’s low-voltage MAINS installation. On page 11, replace Electrical Safety and EMC sections with: General Specifications Maximum working voltage in CAT IV areas: Current measurement: .............................. 600 V ac rms or dc between conductor & ground Voltage measurement ..............................