User's Manual

Manual Supplement



Manual Title: 28 II Ex Calibration Supplement Issue: 4

Part Number: Web-Only Issue Date: 2/14

Print Date: May 2012 Page Count: 2

Revision/Date:

This supplement contains information necessary to ensure the

accuracy of the above manual..

PAGE 1
Manual Supplement Manual Title: Part Number: Print Date: Revision/Date: 28 II Ex Calibration Web-Only May 2012 Supplement Issue: Issue Date: Page Count: 4 2/14 2 This supplement contains information necessary to ensure the accuracy of the above manual.. © 2012-2014 Fluke Corporation. All rights reserved.
PAGE 2
8 II EX Calibration Manual Supplement Change #1, 62942 On page 8, replace Duty Cycle (Vdc and mVdc) with: Duty Cycle (Vdc and mVdc) Range 0.0 % to 99.9 % Accuracy [1] Within  (0.2 % per kHz + 0.1 %) for rise times <1 s. [1] 0.5 Hz to 200 kHz, pulse width >2 s. Pulse width range is determined by the frequency by the frequency of the signal. [2] For 6 V dc range accuracy is unspecified.
PAGE 3
Manual Supplement 28 II EX Calibration Change #3, 65782 On page 4, in the Symbols table, remove CAT III, CAT IV and CSA C1 and add:   Conforms to relevant North American Safety Standards Conforms to relevant South Korean EMC Standards CAT II Measurement Category II is applicable to test and measuring circuits connected directly to utilization points (socket outlets and similar points) of the low-voltage MAINS installation.