Manual Supplement Manual Title: 28 II Ex Getting Started Print Date: November 2011 Part Number 3945752 Revision/Date: Supplement Issue: Issue Date: Page Count: 4 6/13 8 This supplement contains information necessary to ensure the accuracy of the above manual. © 2012-2013 Fluke Corporation. All rights reserved.
8 II EX Getting Started Manual Supplement Change #1, 60849 & 60854 On page 1, replace the third paragraph with: The Product is designed for operation in potentially explosive areas of Zone 1, 2, 21, 22, and M1 as specified in Directive 1999/92/EC and 94/9/EC (ATEX). There can be dangerous consequences If you do not follow these instructions.
28 II EX Getting Started Manual Supplement Ex-Certification Data Ex-Type certificate no: PTB 11 ATEX 2028 X IECEx PTB 11.0080X Ex-Designation: ATEX: II 2G Ex ia IIC T4 Gb II 2D Ex ia IIIC T130 C Db I M1 Ex ia I Ma P0 = negligible Ri = 2.47K Lo/Co IECEx: Ex ia IIC T4 Gb Ex ia IIIC T130 C Db Ex ia I Ma CE: CE0102 Operating Temperature: -15 C to 50 C Storage Temperature: -40 C to +60 C Batteries: 3 AAA Alkaline batteries, NEDA 24A IEC LR03.
28 II EX Getting Started Manual Supplement Lo/Co Lo/mH 1000 100 5 1 0.5 0.005 Co/F 0 14 19 25 30 1000 For measurements on protected electric circuits: Approved for Zones 2 and 1, device group II, explosion group IIC (explosive gases, vapors and mist), temperature class T4. Approved for Zones 21 and 22, device group II, explosion group IIIC, conducting and nonconducting dust, fibers, and flyings. Approved for use in mines. Device group I, explosion group I, methane, and coal dust.
28 II EX Getting Started Manual Supplement On page 22, replace Table 8 with: Table 8. Replacement Parts Qty.
28 II EX Getting Started Manual Supplement Alligator Clips Fuse Assembly *Contains 440 mA Fuse Test Lead Set Fuse 11 A, 1000 V, Fast Amp Jack Plug set 28 II Ex Manual Information Pack grt11.eps Figure 4.
28 II EX Getting Started Manual Supplement On page 24, Replace Table 9 with: Table 9. Accessories Item Description AC172 or AC175 Alligator Clips TL175 Silicone test lead set with probes Amp Jack Plug Set 2 Pack for DMM’s I400 AC Current Clamp [1] 80PK-27 Temperature Probe [2] All accessories in this table are approved for use in explosive hazardous environments. Fluke accessories are available from an authorized Fluke distributor.
28 II EX Getting Started Manual Supplement On page 25, under Temperature replace Storage with: Storage -40 C to +85 C (without battery) -40 C to +60 C (with battery) Change #2, 62942 On page 32, replace Duty Cycle (Vdc and mVdc) with: Duty Cycle (Vdc and mVdc) Range 0.0 % to 99.9 % [1] [2] Accuracy [1] Within (0.2 % per kHz + 0.1 %) for rise times <1 s. 0.5 Hz to 200 kHz, pulse width >2 s. Pulse width range is determined by the frequency by the frequency of the signal.
Manual Supplement 28 II EX Getting Started Change #3, 65782 On page 2, under Safety Information remove The Product complies with: and all the bullets. On page 8, in the Symbols table, remove CAT III, CAT IV and CSA C1 and add: Conforms to relevant South Korean EMC Standards CAT II Measurement Category II is applicable to test and measuring circuits connected directly to utilization points (socket outlets and similar points) of the low-voltage MAINS installation.
