Brochure
Clamp Meter selection chart cont.
Job functions Applications Recommended clamp
Comm/Ind Electrical
Electrical Contractor
Working on panels and branch circuits
• Measure loads on a branch circuit at a
panel (including feeder cables, branch
circuits and neutrals) and the continuity of
switches, fuses and contacts
• Measure load side voltage of a breaker or
fuse
• Check if a circuit is live before beginning
work
T5-1000 Electrical Tester
Key features
• Open jaw ac current measurement to 100 A
• AC and dc voltage
• T5-600: CAT III 600 V
• T5-1000: CAT IV 600 V, CAT III 1000 V
• Continuity, resistance
• Rugged and easy to use
Facility Maintenance
Commercial Electrician
Leakage
Facility Maintenance
Electrician
Measuring leakage current
• Check insulation condition and leakage of
circuits and systems
• Check for leakage in circuits and systems
utilizing filters
Testing insulation on live circuits
• Evaluate insulation condition on live
circuits via leakage current measurements
where disconnection is highly inconvenient
360 AC Leakage Current Clamp Meter
Key features
• Measurement of leakage current with 3 mA range and
1 µA of resolution for accurate monitoring of insulation
erosion
• Broad range of measurement from 1 µA up to 60 A, for
all installation needs
• Advanced shielding to ensure accurate results when
measuring near other conductors
• Easy-to-carry, pocket-sized leakage current tester with
wide 40 mm (1.5 in) jaw size
• CAT III 300 V
Hospital Electrician
Electrical Contractor
Earth Ground
Industrial/Commercial
Maintenance Electrician
Grounding and bonding resistance testing
• Perform ground loop tests in areas where
other ground resistance test techniques are
not available
• Test parts of a multi-grounded system
• Periodically perform quick tests on system
grounds as part of a regular preventative
maintenance program
1630 Earth Ground Clamp Meter
Key features
• Measure from 0.025 Ω to 1500 Ω ground loop
resistance
• Large jaw for clamping around the widest range of
ground conductors or grounding bars
• Measure ground leakage and ac load currents from
0.2 mA all the way up to 30 A
• User defined alarm limits for rapid pass/fail type
measurements
• CAT III 300 V
Utility Technician
Electrical Contractor/
Consultant
Process
Process Technician/
Electrician
Measuring process control signals
• Measures 4-20 mA signals without break-
ing the loop
• Check correct operation of PLCs and control
systems analog I/O
• Source process control signals allow for
testing of 4-20 mA signals and 1 to 5 V
and 0 to 10 V to test automation I/O
• Advanced troubleshooting features simplify
loop testing
773 Milliamp Process Clamp Meter
Key features
• Saves time and money by easily measuring 4-20 mA
signals
• Detatchable miniature clamp for tight locations
• Also measure older 10 to 50 mA signal systems with
the 100 mA range
• Backlit display, spotlight, display hold and zero-reading
buttons
• Eliminates the need for extra 4-20 mA source or
voltage equipment when troubleshooting
• CAT II 300 V
Automation Specialist/
Commercial Electrician