Product Manual

Documenting Process Calibrator

Get Started

Warning

To prevent possible electrical shock, fire, or

personal injury:

• Remove circuit power before you connect

the Product in the circuit when you

measure current. Connect the Product in

series with the circuit.

• Do not touch exposed metal on banana

plugs, they can have voltages that could

cause death.

• Disconnect power and discharge all high-

voltage capacitors before you measure

resistance or continuity.

A brief getting started exercise follows:

1. After you unpack the Product, charge the battery for 8

hours (if the battery is outside of the Product, charge for

5 hours). For more information, see “The Battery”. The

Battery will only charge if the Product is off.

2. Connect voltage output to the voltage input. To do this

connect the left pair of jacks (V Ω RTD SOURCE) to

the right pair of jacks (V MEASURE). See Figure 2.

3. Push o to turn on the Product. If necessary, adjust the

display brightness. See “Display Brightness”. The

Product powers up in the dc voltage measurement

function, and is reading on the V MEASURE pair of

input jacks.

4. Push  to show the SOURCE screen. The Product

still measures dc voltage and the active measurement

is at the top of the display.

5. Push  to select dc voltage sourcing. Push 5 on the

keypad and  to begin sourcing 5.0000 V dc.

6. Push  to go to the split-screen, simultaneous

MEASURE/SOURCE mode. The Product

simultaneously sources dc volts and measures dc volts.

The measurement readings are shown on the top

display, and the active source value on the bottom

display as shown in Figure 3.