Item Brochure
4 Fluke Calibration P3000 Series Pneumatic Deadweight Testers Model P3000
Pressure ranges
Instrumental measurement uncertainty ± 0.015 % of reading (± 0.008 % optional)
Note: For more information on the uncertainty, including the
% reading threshold, please see technical note, "Guide for the
Uncertainty Analysis in Pressure When Using P3000 Series Dead-
weight Testers"
Mass and PCU materials of construction
Standard weight material Series 3 non-magnetic austenitic stainless steel
Density: 7.8 g/cm
3
Optional fine increment masses Aluminum
Density: 2.7 g/cm
3
Piston material Cylinder material Coefficient of
expansion
P3011, P3012, P3013, P3022, P3023,
P3025 (V)
Ceramic Martensitic steel 11 ppm/°C
P3014, P3015, P3025 (P), P3031,
P3032 (P & V)
Tungsten carbide Martensitic steel 16.5 ppm/°C
General
Test port adaptors M14 X 1.5, M20 X 1.5, 1/8 in, 1/4 in, 3/8 in and 1/2 in NPT and BSP
Weight 11 kg (24 lb)
Dimensions (W x D x H) 440 mm x 300 mm x 215 mm (17.5 in x 12 in x 8.5 in)
Mass set weight (typical) 29 kg (65 lb)
Weight increments
Minimum standard weight increments
P3012, P3022 Pressure 1 inH
2
O, (5 mbar, 0.5 kPa)
P3013, P3023 Pressure 2 inH
2
O, (10 mbar, 1 kPa)
P3014, P3015, P3025 Pressure 1 psi, (0.1bar, 10 kPa)
P3031, P3032 1 psi, (0.1bar, 10 kPa)
P3011, P3022, P3023, P3025
Vacuum
0.2 inHg (10 mbar, 1 kPa)
Optional fractional weights
P3014, P3015, P3025 Pressure 0.1 psi (10 mbar, 1 kPa)
Built-in hand pumps
Pressure mode Max pressure 300 psi (2 MPa)
Vacuum mode To 90 % vacuum
Operating fluid for liquid lubricated models
55-655 mineral oil. For oxygen clean applications, please consult factory.
Specications