Product Manual

Remote Commands
Remote Command List 6
6-19
PRES_MEAS
This command changes the primary display operation mode to pressure measurement.
Parameter: <None>
Response: <None>
Example: PRES_MEAS
This example changes the primary display operation mode to
pressure measurement.
PRES_UNIT
This command sets the primary display pressure units.
Parameter: <value>
where <value> is one of these:
PSI pounds per square inch
INH2O4C inches of water at 4 °C
INH2O20C inches of water at 20 °C
INH2O60F inches of water at 60 °F
CMH2O4C centimeters of water at 4 °C
CMH2O20C centimeters of water at 20 °C
MMH2O4C millimeters of water at 4 °C
MMH2O20C millimeters of water at 20 °C BAR bars
MBAR millibars
KPA kilopascals
MPA megapascals
INHG inches of mercury at 0 °C
MMHG millimeters of mercury at 0 °C
KG/CM2 kilograms per square centimeter
Response: <None>
Example: PRES_UNIT BAR
This example sets the primary display pressure units to bars.