Product Manual

Isolated Inputs
Output Setpoints 3
3-7
To recall a setpoint:
1. Select the output mode.
2. Push  and  to select the RECALL function.
3. At the setpoint number selection prompt "RECALL SPT#", push the numeric key, 1
to 9, for the setpoint to be recalled.
To start an automatic setpoint cycle:
1. Select the output mode.
2. Push  and  to select the AUTOSET function.
3. At the end setpoint number selection prompt "AUTO SET POINT", push the numeric
key, 1 to 9, for the end setpoint number for the cycle.
4. At the dwell time prompt "DWELL TIME", "5-500?", record the number of seconds,
5 to 500, to dwell at each setpoint value, followed by E.
5.  can be used at any time during the cycle without stopping it.
6. Push the other Product keys to stop the cycle.