Product Manual

7526A
Users Manual
5-10
Table 5-3. Commands for RS-232 Only
IEEE-488 Message RS-232 Equivalent
GTL LOCAL command
GTR REMOTE command
LLO LOCKOUT command
8. Commands for IEEE-488
These are all of the commands but those used for RS-232 only, as shown above. All
commands are moved through the IEEE-488 as data, but the commands LOCAL,
REMOTE, and LOCKOUT, which are done per the IEEE Standards as uniline
messages.
The detailed command descriptions in Chapter 6 show a check mark beside IEEE-
488 for these commands.
Command Syntax
The subsequent syntax rules are for all of the remote commands. Information about the
syntax of response messages is also given.
1. Parameter Syntax Rules
Table 5-4 shows the units permitted in command parameters and used in responses.
All commands and units can be recorded in upper or lower case.