User's Manual
Table Of Contents
- Table of Contents
- General Aspects
- About This Manual
- Features of Fluke 434-II/435-II/437-II
- Basic Operations and Menu Navigation
- Display Information
- Input Connections
- Scope Waveform and Phasor
- Volts/Amps/Hertz
- Dips & Swells
- Harmonics
- Power & Energy
- Energy Loss Calculator
- Power Inverter Efficiency
- Unbalance
- Inrush
- Monitor - Power Quality Monitoring
- Flicker
- Transients
- Power Wave
- Mains Signaling
- Logger
- Shipboard V/A/Hz
- Cursor and Zoom
- Setting up the Analyzer
- Using Memory and PC
- Tips and Maintenance
- Specifications
- Appendices
- Index
Setting up the Analyzer
MANUAL SETUP24
24-11
f
Use the arrow keys to highlight 3φ IT. Then press
ENTER to confirm the selection.
g
ENTER
The diagram shows in detail how to connect
voltage and current probes to the power system
under test.
h
F5
(3x)
Return to Setup entry screen. The new
configuration is indicated behind Config. and the
belonging configuration symbol is shown on the
right side of the screen.
Manual Setup - How to change scale of Scope Display
The example below shows stepwise how to adjust Scope display scaling of the phase
voltages.
c
The voltage waveforms of the Phases are outside
the viewing window.